Korean Auto Guide Hyundai & Kia ownership, explained
Parts Guides

Heavy or Noisy Steering: Electric Power Steering Faults

Almost every Hyundai and Kia since the mid-2000s uses electric power steering, which fails in ways a hydraulic system never did. Here is what a heavy wheel, an EPS light and a column clunk each mean — and why the most expensive repair is rarely the right one.

By Korean Auto Guide editorial team Updated 16 November 2026 8 min read

The short answer

  • Heavy steering with an EPS light means the assist has been reduced on purpose. Read the code before buying a rack.
  • Clunk or play in the wheel over small bumps is usually the intermediate shaft or its rubber coupling, not the motor.
  • A weak battery can cause it. Electric assist draws a lot of current; rule out the charging system first.
  • Wander or a wheel that sits off centre after an alignment points at the steering angle sensor calibration.

How electric assist works

A hydraulic system used engine-driven pressure to push a piston in the rack. An electric system uses a motor — mounted on the column on most Hyundai and Kia models, on the rack on some — plus a torque sensor that measures how hard you are turning, and a control unit that decides how much help to give.

LayoutWhere it appearsWhat fails most
Column-mounted motor (C-EPS)i10, i20, Picanto, Rio, Accent, most small carsTorque sensor, column coupling, motor
Rack-mounted motor (R-EPS)Larger models — Tucson, Sportage, Santa Fe, sedansMotor or control unit, rack internals
Hydraulic with electric pumpSome earlier and commercial modelsPump, fluid, pressure lines

Because the assist is electronic, the failure modes are electrical as much as mechanical: a sensor can drift, a motor can develop a dead spot, a control unit can lose its calibration, and a low supply voltage can make the whole system behave oddly without anything being broken.

The symptoms and what they point to

SymptomMost likelyNotes
Heavy all the time, EPS light onReduced-assist mode after a detected faultRead codes; the system is telling you exactly what it lost
Heavy in one direction onlyTorque sensor or motor phase faultUncommon but distinctive; needs a proper diagnostic
Assist cuts out at idle or when parkingVoltage drop — battery or chargingCheck battery and earth straps before steering parts
Clunk over small bumps, play at the wheelIntermediate shaft universal joint or rubber couplingA classic wear item on high-mileage cars
Whine or motor noise when turningMotor or its gear reductionSome motor noise is normal; a new loud whine is not
Wheel off centre, wander, ESC lightSteering angle sensor calibrationCommon after an alignment or a battery change
Vibration through the wheel at speedWheel balance, tyre, or a failing bearingNot a steering-system fault at all

What you can check yourself

  1. Battery and charging. Voltage at rest and while running, plus the condition of the earth straps. Electric assist is a big load, and a marginal battery produces intermittent assist loss long before it fails to start the car.
  2. Parked play test. With the wheels straight and the car stationary, rock the wheel gently left and right. A distinct knock with free play before the wheels move points at the intermediate shaft or coupling; a tight wheel with no play points elsewhere.
  3. Tyre pressures and wear. Low pressure or uneven wear pulls the wheel and mimics a steering fault.
  4. Listen while turning. A periodic click as the wheel passes a point suggests a coupling or a motor dead spot; a constant whine is the motor.
  5. Have the codes read from the steering module. Generic engine readers often cannot see the EPS module. A tool that can read body and chassis modules will name the sensor or the circuit.

The voltage connection

A steering system that behaves badly only at idle, or only when several electrical loads are on, is worth checking at the battery first. Pumps, blowers and headlights all compete, and the assist reduces when voltage sags. On these cars an aging battery combined with corroded earth straps produces exactly the intermittent heaviness owners describe as "the steering sometimes goes funny in car parks".

What the repair involves

JobWhat is involvedWhat moves the bill
Battery / earth strapBattery, clamps, earth braidOften the cheapest cure for intermittent assist loss
Steering angle calibrationDiagnostic session, wheels straight, module resetLabour only; needed after alignment or battery work
Column coupling / intermediate shaftLower dash trim off, shaft or coupling replacedWhether the coupling is sold separately or only with the shaft
Torque sensorColumn or sensor replaced depending on the designSome sensors are not serviceable separately — the column is replaced
EPS motorColumn or rack motor replacedColumn-mounted motors are usually the cheaper of the two
Steering rackRack replaced, then alignment and calibrationThe largest item. Confirm the fault is in the rack before authorising it
EPS control unitModule replaced and coded, sometimes needs the VINProgramming, and whether the unit is shared with other functions

Two questions worth asking before a rack is replaced: what code was stored, and does the assist fail in both directions or only one. A rack replacement for a torque sensor fault, or a column replacement for a worn coupling, is the most common expensive mistake in this system.

If the assist fails completely

Manual steering effort rises sharply, especially at parking speed, and the car will still steer — but it will feel heavy and slow. Reduce speed, avoid tight manoeuvres, and do not attempt a long drive. On a car with a sudden total loss, stop somewhere safe and get it recovered rather than discovering the effort needed for an emergency swerve.

Keeping it healthy

  • Keep the battery in good condition and clean the earth points.
  • Have the alignment checked after kerb strikes; a bent component loads the system and wears tyres.
  • Do not hold the wheel against full lock for long periods while stationary.
  • Do not ignore a clunk. A worn coupling is cheap; the play it introduces wears the shaft splines too.
  • Have the angle sensor recalibrated after any alignment, column work or battery replacement on a car that shows an ESC light.

Frequently asked questions

Why is my steering heavy at low speed?

Assist is greatest at low speed, so a change there means the assist dropped. A torque sensor, motor or supply voltage fault, usually with a code stored.

What is the clunk in the column?

Worn intermediate shaft joints or the rubber coupling. It is mechanical wear, and far cheaper than a rack.

Can a weak battery cause it?

Yes. Electric assist draws high current, and low voltage causes assist drop-outs, especially while parking.

Does it need calibration after repair?

Usually. The steering angle sensor is reset after alignment, column work or a battery change that disturbs the module.

Is a slight motor whine normal?

A faint whine while turning at parking speed is normal on column-mounted systems. A new, loud or grinding noise is not.

General information only. Steering system layout, serviceable components and calibration procedures differ by model, model year and market. Steering is safety-critical: any loss of assist, play or noise should be inspected by a qualified technician before the car is driven at speed.