The short answer
- No crank, bright lights: starter, starter relay or the signal to it — not the battery.
- Slow crank, dim lights: battery charge, terminals or earth strap.
- Starts fine, battery flat next morning: a parasitic drain, and a new battery will not fix it.
- Battery light while driving: the alternator is not charging — you have roughly as far as the battery's reserve, so drive to a workshop rather than home.
Four faults that look identical
"It won't start" covers a flat battery, a dead starter, a charging fault and an immobiliser refusal. Each has a different sound and a different first check.
| What you hear and see | Most likely | First check |
|---|---|---|
| One loud click, lights bright, nothing turns | Starter solenoid or starter motor | Battery voltage while a helper turns the key; tap test on the starter body |
| Nothing at all, dash dead | Flat battery, main fuse, or a bad earth | Battery voltage at the terminals |
| Rapid clicking, dash flickering | Battery too flat to hold the solenoid | Voltage drops below about 9.6 V while cranking |
| Slow, laboured cranking that catches | Battery on its way out, or a poor connection | Terminal condition and voltage before and during cranking |
| Cranks normally but will not fire | Fuel or immobiliser, not the battery | Immobiliser symbol on the dash; see the key guide |
| Starts, then battery light stays on | Alternator or its belt | Voltage across the battery with the engine running |
The three-minute test everyone should know
A basic digital multimeter is enough for most of this, and the numbers are simple.
| Measurement | Healthy reading | What a bad reading means |
|---|---|---|
| Battery at rest, engine off, after standing | About 12.6 V | 12.2 V is roughly half charged; below 12.0 V is flat |
| While cranking | Above about 9.6 V | Drops further — battery weak, or a poor connection adding resistance |
| Engine idling, no loads | About 13.8–14.4 V | Stays near 12.5 V — alternator not charging |
| Engine running with lights and blower on | Still above about 13.2 V | Sags under load — alternator weak or belt slipping |
| Voltage drop across the earth strap while cranking | Under about 0.2 V | Higher means a corroded earth, which mimics a flat battery |
Do this with the battery terminals clean and tight. A surprising share of "dead battery" calls are a loose clamp or a terminal furred with corrosion, and that costs nothing to fix.
Why the charging system is not a simple circuit
On most Hyundai and Kia models from the mid-2010s onward, the alternator is controlled by the engine computer rather than a fixed internal regulator. The system measures current at the battery through a sensor on the negative cable and decides how hard to charge. That is how stop-start and brake energy recuperation work: the car charges hard when you are off the throttle and lets the battery carry the load when you are accelerating.
Three practical consequences follow. First, a voltage that sits around 12.5–13.0 V at idle is sometimes normal on these cars, so a low reading alone does not condemn the alternator — check it under load and while driving. Second, the battery sensor learns the battery's age, and a new battery fitted without adaptation can be charged conservatively. Third, a failing sensor can cause overcharging, which quietly destroys a battery and sometimes a control module.
Never disconnect the battery with the engine running
Disconnecting a battery to "test the alternator", an old trick from cars with generators, can spike the electrical system on a modern vehicle and damage control modules. Use a meter, not a disconnect.
Finding a parasitic drain
A battery that goes flat in a day or two, on a car that charges correctly, has something drawing current when it should be asleep.
- Charge the battery fully first. A partly charged battery makes the test meaningless.
- Lock the car and wait. Modules can take 20–60 minutes to go to sleep. Leave the bonnet open but latch the catch so the car believes it is closed.
- Clamp the negative cable with a DC clamp meter and read the current. A healthy car settles at a few tens of milliamps; a drain of a few hundred milliamps will flatten a battery overnight.
- Pull fuses one at a time to find the circuit, rather than guessing. Note what each fuse protects before you remove it.
- Check the usual suspects first: a dash camera on a permanent live, an aftermarket alarm or tracker, a boot lamp that stays on, a USB charger left in a socket, or a body control module that will not sleep.
A common pattern on older cars is a boot or tailgate that does not quite latch, leaving the luggage lamp on out of sight. Another is a hands-free or stereo installation tapped into a permanent feed.
What the repair involves
| Job | What is involved | What moves the bill |
|---|---|---|
| Terminal clean | Baking soda, a brush, a thin film of grease | Nothing but time — do it before anything else |
| Battery replacement | Correct group size, capacity and chemistry; terminal clamp and hold-down checked | AGM versus conventional, capacity, and whether adaptation is needed |
| Earth strap | Gearbox-to-body braid or a new cable end | A cheap part that causes expensive-looking faults |
| Starter motor | Unit replaced or solenoid only; intake or battery box may have to come out | Access, and whether the ring gear is worn |
| Alternator | Unit replaced, belt and tensioner checked at the same time | Whether it is a simple external unit or one with a control module; belt condition |
| Battery sensor / adaptation | Sensor replaced or adaptation reset with a scan tool | Whether the tool can access the body control module |
Two habits at the counter: ask for the battery's production date, because a battery that has sat on a shelf for two years starts its life half worn; and ask whether the alternator price includes the belt and tensioner, since a worn belt can produce the same fault a week later.
Getting more life out of a battery
- Short trips do not recharge. Ten minutes of town driving uses more than it puts back; take a longer run occasionally.
- Do not leave the car unused for weeks. Batteries self-discharge, and a deeply discharged battery loses capacity permanently.
- Keep terminals clean and tight. Corrosion adds resistance and makes the charging system work harder.
- Fix a drain, do not mask it with a bigger battery or a solar trickle panel.
- Expect four to six years from a good battery in a moderate climate, less in sustained heat.
Frequently asked questions
How do I tell a flat battery from a starter?
Bright lights and a single click mean power is there and the starter is not turning. Dim lights and a slow crank mean the battery or the connections.
Why does it go flat overnight?
A parasitic drain. Measure current at the negative cable after the car has gone to sleep and pull fuses to find the circuit.
Does a new battery need registering?
On cars with a battery sensor and stop-start, the adaptation should be reset. Many relearn over a few drive cycles; others need a scan tool.
Can I use a normal battery instead of AGM?
Not on a stop-start car. The charge strategy will destroy a conventional battery early and may trigger charging and stop-start faults.
How far can I drive with the battery light on?
Only as far as the battery's reserve — often 20 to 40 minutes with lights and wipers off. Drive to a workshop, not home, and turn off everything you do not need.
General information only. Charging strategy, battery technology and adaptation procedures differ by model, model year and market. High-current electrical work carries a risk of burns and module damage; have charging-system faults confirmed by a qualified technician.